phosphocreatine comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2025-01-25. Where a claim depends on a specific study, the study is described rather than over-claimed.
Sourcing and verification of creatine monohydrate involve both manufacturing origin and third-party testing. Industrial production commonly starts with sarcosine and cyanamide, followed by crystallization to obtain the monohydrate. Some products are derived from animal sources, while others are synthesized from non-animal precursors. Certificates of analysis report assay, heavy metals, and microbial limits. Regulations differ by country: in the United States it is sold as a dietary supplement, whereas in the European Union it falls under food supplement rules.
In solid form, creatine monohydrate is relatively stable when kept dry and away from heat. Moisture and elevated temperatures promote cyclization into creatinine, a related compound with no role in the phosphagen system. Degradation accelerates in aqueous solution, where the conversion can occur within hours to days depending on pH and temperature. Manufacturers typically recommend storage in sealed containers at room temperature, with relative humidity below 50 percent. Long-term stability data for opened containers are limited.
The compound was identified in the nineteenth century after chemists isolated a nitrogenous substance from meat extracts. Later work established its role in muscle energy metabolism and its conversion to phosphocreatine. Chemical synthesis of creatine followed, and industrial production made the monohydrate widely available as a purified powder. Interest expanded in the late twentieth century when researchers began studying creatine supplementation and muscle physiology. Historical accounts sometimes differ on exact dates and attributions, but the broad sequence from tissue extracts to synthetic production is well documented.
In the body, creatine is obtained from dietary meat and fish and is also synthesized from arginine, glycine, and methionine. Muscle stores creatine and phosphocreatine, which participate in the rapid regeneration of adenosine triphosphate during short, intense activity. The monohydrate form is used in research because it is chemically defined, stable as a dry solid, and relatively inexpensive to produce. Questions remain about whether other creatine forms offer meaningful advantages in absorption or tissue retention, and findings vary across studies and populations.
Creatine monohydrate is a crystalline compound formed from creatine and one molecule of water. Creatine itself is a nitrogen-containing organic acid that occurs in vertebrate muscle and other tissues. The monohydrate designation refers to the water included in the crystal lattice, not to water added during manufacturing. Its chemical formula is commonly written as C4H9N3O2·H2O. The solid is typically a white, odorless powder with low solubility in water at room temperature. It is one of several creatine forms described in scientific and commercial literature.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 15–25 °C | Cool, dry, away from moisture |
| Relative humidity | < 50% | High humidity promotes degradation |
| Primary degradation product | Creatinine | Formed via cyclization, especially in solution |
| Common analytical method | HPLC-UV | Often at 210 nm; also titration or NMR |
| Shelf life (solid) | 2–3 years | When kept sealed and dry; varies by manufacturer |
Solid creatine monohydrate is generally stable when kept cool and dry, but it can hydrolyze to creatinine over time. Moisture, heat, and acidic conditions accelerate this conversion, which reduces assay values and changes the material's properties. Creatinine is a cyclic dehydration product that is also a normal human metabolite, so its presence in a sample is not necessarily a health concern by itself. In quality testing, creatinine is monitored as a marker of degradation and purity.
Identity and purity are assessed with several complementary methods. High-performance liquid chromatography can separate creatine from creatinine and related impurities, often with ultraviolet detection. Nuclear magnetic resonance and infrared spectroscopy provide structural confirmation, while Karl Fischer titration measures water content. Elemental analysis and mass spectrometry may be used for additional confirmation, especially in research or forensic settings. No single method captures every quality attribute, so laboratories typically combine results and compare them against a specification.
Analytical laboratories commonly identify creatine monohydrate by high-performance liquid chromatography with ultraviolet detection, often after dissolving the sample in water or dilute acid. Ion-exchange or reversed-phase columns separate creatine from creatinine and related guanidino compounds. Nitrogen content can be checked by Kjeldahl or combustion methods, while moisture is measured by Karl Fischer titration or loss on drying. These techniques give complementary views: chromatographic purity addresses related substances, whereas moisture and elemental data confirm hydrate stoichiometry. No single test defines quality by itself; a combination is used in specifications.
Storage recommendations generally emphasize a cool, dry place away from direct sunlight and strong oxidizers. Sealed containers limit humidity exchange, which helps prevent clumping and gradual conversion to creatinine. Long-term stability studies usually monitor appearance, moisture, and purity at intervals under defined temperature and humidity conditions. Accelerated tests at elevated temperature can reveal degradation pathways, but they do not perfectly predict room-temperature shelf life. Questions remain about how much creatinine formation is acceptable in different product categories and how packaging choices affect that rate over time.
Commercial creatine monohydrate is typically manufactured through chemical synthesis, often starting from sarcosine and cyanamide. The resulting material is crystallized, washed, and dried to a specified hydrate content. Finished lots are tested for identity, purity, moisture, and heavy metals before release. Because the compound can cyclize to creatinine under heat or prolonged storage in solution, manufacturers control temperature and humidity during processing. The solid itself is relatively stable when kept dry and sealed, but moisture uptake can cause caking and complicate accurate assay.
Stability studies typically examine the effects of temperature, humidity, and light on creatine monohydrate. Sealed containers stored in cool, dry conditions help limit moisture uptake and hydrolysis. Elevated temperature and high relative humidity can accelerate conversion to creatinine, especially in aqueous solutions. In solid dosage forms, excipients and processing steps may also affect stability. Published stability data are not fully consistent across studies because test conditions and analytical methods vary.
Quality control of creatine monohydrate relies on a combination of identity, purity, and moisture tests. High-performance liquid chromatography with ultraviolet detection is widely used to separate creatine from creatinine and other related nitrogenous compounds. Spectroscopic methods such as infrared and nuclear magnetic resonance provide structural confirmation. Because the material is a hydrate, water content is measured separately, often by Karl Fischer titration. These tests together establish whether a lot meets a defined specification.
Manufacturing processes can leave trace amounts of dicyandiamide, creatinine, or residual solvents, depending on the synthetic route and purification steps. Heavy metals, arsenic, and microbial contamination are also monitored for food or pharmaceutical grades. Particle size distribution can affect dissolution behavior and blending uniformity, so it may be specified for certain applications. Analytical results are reported on a dry basis or as-is basis, and the difference matters when comparing certificates of analysis. Open questions remain about how minor impurities influence long-term stability under varied storage conditions.
In an experiment described in the 2016 paper, rhesus macaques were infected with Ebola virus and treated with a combination of ansuvimab and another antibody isolated from the same subject, mAb100. Three doses of the combination were given once a day starting 1 day after the animals were infected. The control animal died and the treated animals all survived. In a second experiment described in the 2016 paper, rhesus macaques were infected with Ebola virus and only treated with ansuvimab. Three doses of ansuvimab were given once a day starting 1 day or 5 days after the animals were infected. The control animals died and the treated animals all survived. Unpublished data referred to in a publication of the 2018 Phase I clinical trial results of ansuvimab, reported that a single infusion of ansuvimab provided full protection of rhesus macaques and was the basis of the dosing used for human studies.
An analytical ultracentrifuge has a light source and optical detectors. To allow the light to pass through the analyte during the ultracentrifuge run, specialized cells are required which have to meet high optical standards as well as to resist the centrifugal forces. Each cell consists of a housing, two windows made from optically pure quartz glass, and a centrepiece with one or two sectors and filling holes for the sector(s), closed with a screw plug in the housing. These cell are placed into a rotor cavity with a continuous bore, with a collar at the bottom to retain the cell. By applying specific equipment and adapting measurement parameters several types of experiments can be performed. Most common AUC experiments are sedimentation velocity and sedimentation equilibrium experiments.
The European Aviation Safety Agency (EASA) is tasked by Article 15(4) of Regulation (EC) No 216/2008 of the European Parliament and of the Council of February 20, 2008, to provide an annual review of aviation safety. The Annual Safety Review presents statistics on European and worldwide civil aviation safety. Statistics are grouped according to type of operation, for instance, commercial air transport, and aircraft category, such as aeroplanes, helicopters, gliders, etc. The Agency has access to accident and statistical information collected by the International Civil Aviation Organization (ICAO). States are required, according to ICAO Annex 13, on Aircraft Accident and Incident Investigation, to report to ICAO information, on accidents and serious incidents to aircraft with a maximum certificated take-off mass (MTOM) over 2250 kg. Therefore, most statistics in this review concern aircraft above this mass. In addition to the ICAO data, a request was made to the EASA Member States to obtain light aircraft accident data. Furthermore, data on the operation of aircraft for commercial air transport were obtained from both ICAO and the NLR Air Transport Safety Institute.
The α2 receptor couples to the Gi/o protein. It is a presynaptic receptor, causing negative feedback on, for example, norepinephrine (NE). When NE is released into the synapse, it feeds back on the α2 receptor, causing less NE release from the presynaptic neuron. This decreases the effect of NE. There are also α2 receptors on the nerve terminal membrane of the post-synaptic adrenergic neuron. Actions of the α2 receptor include: decreased insulin release from the pancreas increased glucagon release from the pancreas contraction of sphincters of the GI-tract negative feedback in the neuronal synapses - presynaptic inhibition of norepinephrine release in CNS increased platelet aggregation decreases peripheral vascular resistance α2 agonists (see actions above) can be used to treat: hypertension – decrease blood pressure-raising actions of the sympathetic nervous system α2 antagonists can be used to treat: impotence – relax penile smooth muscles and ease blood flow depression – enhance mood by increasing norepinephrine secretion Subtype unspecific β agonists can be used to treat:
Sources: en.wikipedia.org
On 1 December 1978, the Health and Safety Executive announced their intention to prosecute the university for breach of safety legislation. The case was heard in October 1979 at Birmingham Magistrates' Court. Although the source of infection was traced, the mode and cause of transmission was not. Evidence presented by several internationally recognised experts, including Kevin McCarthy, Allan Watt Downie and Keith R. Dumbell, showed that airborne transmission from the laboratory to the telephone room where Parker was supposedly infected was highly improbable. The experts calculated that it would require 53,700 litres (11,812 imp gal) of virus fluid to have been aspirated (meaning, in this context, removed by suction of fluid and cells through a needle) and it would take 20,000 years for one particle to travel to the telephone room at the rate the fluid was aspirated. It was additionally found that although the Shooter Inquiry noted the poor state of the duct sealing in the laboratory, this was caused after the outbreak by engineers fumigating the laboratory and ducts. The university was found not guilty of causing Parker's death.
Amino acid N-carboxyanhydrides, also called Leuchs' anhydrides, are a family of heterocyclic organic compounds derived from amino acids. They are white, moisture-reactive solids. They have been evaluated for applications the field of biomaterials. NCAs are typically prepared by phosgenation of amino acids: They were first synthesized by Hermann Leuchs by heating an N-ethoxycarbonyl or N-methoxycarbonyl amino acid chloride in a vacuum at 50-70 °C: A moisture-tolerant route to unprotected NCAs employs epoxides as scavengers of hydrogen chloride. This synthesis of NCAs is sometimes called the Leuchs method. The relatively high temperatures necessary for this cyclization results in the decomposition of several NCAs. Of several improvements, one notable procedure involves treating an unprotected amino acid with phosgene or its trimer. NCAs are prone to hydrolysis to the parent amino acid: RCHNHC(O)OC(O) + H2O → H2NCH(R)CO2H + CO2 Some derivatives however tolerate water briefly. NCAs convert to homopolypeptides ( [N(H)CH(R)CO)]n) through ring-opening polymerization:
According to the fluid mosaic model of S. J. Singer and G. L. Nicolson (1972), which replaced the earlier model of Davson and Danielli, biological membranes can be considered as a two-dimensional liquid in which lipid and protein molecules diffuse more or less easily. Although the lipid bilayers that form the basis of the membranes do indeed form two-dimensional liquids by themselves, the plasma membrane also contains a large quantity of proteins, which provide more structure. Examples of such structures are protein-protein complexes, pickets and fences formed by the actin-based cytoskeleton, and potentially lipid rafts.
Sources: en.wikipedia.org
Yes, especially when exposed to moisture or heat, where it converts to creatinine. In dry, sealed containers at room temperature, degradation is slow and the product may remain within specification for two to three years.
Common methods include high-performance liquid chromatography, titration, and nuclear magnetic resonance spectroscopy. These techniques quantify the parent compound and detect related substances such as creatinine.
Keep the powder in a tightly sealed container in a cool, dry place, ideally between 15 and 25 degrees Celsius with low humidity. Avoid storing aqueous solutions for extended periods because degradation occurs faster in solution.
It is a crystalline form of creatine that contains one water molecule per creatine molecule. The compound occurs naturally in muscle tissue and is also produced synthetically for research and consumer products. The monohydrate label describes the solid's hydration state.